Steel Roof/Wall Sheet Roll Forming Machine
Steel Roof/Wall Sheet Roll Forming Machine
Steel sheets forming machine; Steel Corrugated Sheet Roll Forming Machine; Steel Sheet Roll Forming Machine; Roll forming machine; Forming machine; Cold roll forming machine.
Main components:
The uncoiler and its base
Coil sheet guiding and adjusting equipment
Film covered device
Main roll forming system
Postcutting device
Hydraulic station
PLC control systerm
Support table
The Technical parameters:
Suitable raw material: Color steel sheet; Galvanized steel sheet
Thickness of the material: 0.4m to 0.7mm
Yield strength of material: 235Mpa
Uncoiler's loading capacity: Max. Capacity: 5000Kgs. (can be increased to be 10 tons)
Forming speed: About 15m/min roll former
Main motor power: 5.5Kw(Depend on final design)
Hydraulic station power: 2.2Kw(Depend on final design)
Controling systerm: Mitsubishi PLC & converter
Voltage: 380V, 3 phase 60Hz or according to at buyer's requirment.
The quantity of the roller group: At lest 15 groups(depend on final design)
Machine dimension: About 20m*1.5m*1.4m(depend on final design)
Total weight: About 10000kgs(depend on final design) forming machine
Material of Roll former system
Roller: High grade No. 45 forged steel, plated hard chromed on the surface of rollers
With thickness 0.05mm.
Active shaft material: High grade No. 45 carbon wrought steel at diameter 75mm.
Working flow
Decoiling the sheetguiding the sheetcovering the filmroll formingmeasuring the lengthcutting the panelpanels to the supporter
上一篇：Roll Forming Machine for Roof Panel
下一篇：Roof Tile Machine