Steel Plate Roll Forming Line
Steel Plate Roll Forming Line
A: Technical parameters:
1. Material spec: Colored steel sheet, galvanized steel sheet
2. Thicknedd of coil sheet: 0.4-0.8mm
3. Main motor powder: 5.5 KW
4. Forming speed: 16m/min
5. Hydraulic pressure: 10-12 Mpa
6. Quantity of stands: About 12 groups
7. Hydraulic station power: 3 KW
8. Controlling system: PLC
9. Index error of length: 10m-2mm
10. Total weight: About 3.2T
11. Voltage: 380V 3 phase 60Hz or at buyer`s requirement.
B: Material of main equipment:
1. Roller material: High grade No. 45 forged steel, plated hard chrom on the surface of roller with thickness 0.05mm
2. Active shaft material: High grade No. 45 carbon wrought steel at diameter 75mm
3. Cutter blade: Cr12 mould steel with quenched treatment
4. The panel surface no scratch
5. Frequency converter
6. PLC: Computer adopt PLC
7. Computer operating board adopt OP320A, China.Roll Forming Machine
Wall Panel Forming Machine
Roof Panel Forming Machine
Double Layer Forming Machine
Floor Deck Forming Machine
Glazed Tile Forming Machine
C/Z Purlin Forming Machine
Roll Shutter Door Forming Machine
Ridge Cap Forming Machine
Guardrail Forming Machine
Downpipe Forming Machine
Dust Shield Forming Machine
Arch Machine
slitting machine,shearing,bending machine
EPS Sandwich Panel Production line
uncoiler machine & stacker machine
Uncoiling, Leveling, Shearing, Collecting line