840 wall panel roll forming machine



 Introduction

Machine consist of uncoiler and its base, coil sheet guiding equipment, film covering device, roll forming system, post cutting equipment, hydraulic station, controlling system, supporter table. 
 
Roll forming machine
Technical Parameters:
Material Spec: colored steel sheet; galvanized steel sheet
Thickness of coil sheet: 0.3-0.8mm
Main Motor Power: 4 kw roll former forming machine 
Forming Speed: 10-12m/min
Hydraulic station power: 3kw roll forming 
Quantity of stand:about 14 or 16 stands
Hydraulic pressure:10-12mpaCold Forming Machine  
controlling system: PLC
Index error of length:10m+2mm
Total weight: about 6 tonsCam Unit Die Setting components
Voltage: 380V 3phase 60 HZ or at buyer's requirement
 
Material of main equipment
Cold Roll Forming Machine
Roller material: high grade NO.45 forged steel, plated hard chrome on the surface of roller with thickness 0.05mm
 Double Layer Forming Machine

 

 
Active shaft material: high grade NO.45 carbon wrought steel at Φ 72mm
Cutting blade: Cr12 mould steel with quenched treatment.Floor Deck Forming Machine
 
 
 
 
 

 

上一篇:950 Glazed Tile Roll Forming Machine 下一篇:900 wall panel roll forming machine